Mini Split Heating and Cooling. Provide adequate room.
When installing your new heating and cooling equipment, your contractor should do the following to ensure a quality installation: Provide adequate room around the equipment for service and maintenance. Install and set up a programmable thermostat (if not already in use).
Split System HVAC Units is for You. Test and Verify.
Show you how to change the filter(s). Test and verify proper airflow (if a furnace or heat pump). Verify that your furnace or boiler has been tested for proper burner operation and proper venting of flue gases. The vent piping should be inspected for leaks or deterioration and repaired or replaced as necessary.
Senville Split System Heating and Cooling is for your Family. Install a Properly Matched Indoor.
Install a properly matched indoor coil when replacing an outdoor unit. An old coil will not work efficiently with a new outdoor unit. Confirm that the level of refrigerant charge and the airflow across the indoor coil meets the manufacturer’s recommendation. It’s estimated that more than 60 percent of central air conditioners are incorrectly charged during installation.
Place the condenser in an area that can be protected from rain, snow, orvegetation, as specified by the manufacturer. If you have a central air conditioning unit, cover your outside equipment during the winter to protect it from snow and ice. Heat pumps need to be left uncovered to properly operate during the winter.
Mini Split AC in the USA 