Front panel air filter (under the front panel), grill horizontal air flow, air flow grill vertical temperature sensor (inside the indoor unit), panel, infrared signal receiver, refrigerant gas connector, remote control, cable, sensing valve, drain hose and refrigerant pipe connection. Indoor unit: The air handling section, climatizadora unit is installed near local conditioning or cooling and which includes the evaporator fan.
The outdoor unit should be installed on the flat rigid or concrete base since it is quite heavy. The unit will vibrate excessively if it is installed on some loose, vibrating or hanging base. Outdoor Unit: The condensing unit, which must be installed on the outside of the premises or contains the compressor and condensador. All This, coupled by the corresponding refrigerant connections.
It is in charge of room temperature and cut the heating or cooling system when the temperature, get to the desired temperature. In air conditioning systems have temperature sensors located in the indoor unit. The thermostat does this by switching heating or cooling devices on or off, or regulating the flow of a heat transfer fluid as needed, to maintain the correct temperature.
Split systems consist of two units, one internal and one external, linked together through copper pipes. In summer, the indoor unit gets heat from the room and dump it outside. While the device is inside also distributes fresh and clean air in the room, in a uniform way to prevent drafts.