How to Install a Split Unit AC? Disassemble.
You should rinse each component individually for best results. Not only will you get a better end result, but also end the rinsing process faster. In general errors should rinse upper annexed hose system and the compressor in the bottom. Depending on the dirtiness of the capacitor can therefore be impossible to properly clean and therefore it should be replaced. Remove the condenser for better result. Of enough rinsate into the opening and shake the condenser.
Parts Of an Air Conditioning System. Start the rinsing process.
Depending on the method used, should give first a little detergent in the part. With pressurized gas (nitrogen or dry air) can press the detergent through the part. Keep a clean windshield in the front of the rinse.
How to Install a Mini Split Air Conditioner? Putting the Pieces.
Assemble all parts again. The dryer or replacement deposit should be the last to mount, just before the vacuum.
Installing Mini Split Heat Pump. Vacuum, leak detection and Replenishment.
Now you can start the whole system vacuum assembly. The deep vacuum should be applied for at least one hour. Even when rinsing is also the evaporator, it is recommended to lengthen the time less than 2 hours.
